Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
FIG AS150 AS 150 Channel
AS150, AS150EH. AS150KO, AS150H, AS150S Channel Submittal
AS 888 Four Hole Splice Plate
AS 1000AS EMT Conduit Clamps
291 Clevis Pin w/ Cotters
AS 661 T2 Strut Bracket (Slot Down)
AS 756 "Z" Support
AS 710 "U" Support
AS 400H Channel with Holes
AS SS Clamping Nut with Short Spring
H-Pad Slip Sheet
AS 2128 RH & LH Six Hole Corner Connector