Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
FIG AS200H3 AS 200H3 Channel with Holes on all Three Sides
AS200, AS200EH, AS200KO, AS200H, AS200S, AS200H3 Channel Submittal
AS 0040D thru AS 106P Cushion Clamp Assembly
AS 668 Six Hole Three Angle Connector
AS NS Clamping Nut w/o Spring
226 Truss Bracket
AS 209 Flat Washer
AS 3064 Double Column Post Base
AS 653 Type "B" End Cap Anchor
274P Cast Iron Base Plate Only
67 Pipe or Conduit Hanger
244 Pipe Strap - Round