Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
Stud End Clutch
AS SS Clamping Nut with Short Spring
AS 9403 Three Hole Hinge Connector
AS 668 Six Hole Three Angle Connector
AS 100S Channel with Long Slots
88 C-Clamp w/ Set Screw Only
161 1.5" Pipe Covering Protection Saddle
137S Special U-Bolt
Seismic Shield Insulation Protection Shield
AS 661 T1 Strut Bracket (Slot Up)
AS200, AS200BTB, AS200BTS, AS200STS, AS200STSR Welded Channel Submittal