Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
AS 150EH Channel with Elongated Holes
185 CPVC One Hole Pipe Strap
AS 686 Beam Clamp
93 Universal C-type Clamp Wide Throat
AS 612 "Z" Support
AS 652 Type "B" End Cap Anchor
AS 821 Eight Hole Double Angle Connector
255 Pipe Alignment Guide
AS 633 Two Hole Open Angle Connector
AS 655 & AS 656 Type "A" End Caps
AS200, AS200BTB, AS200BTS, AS200STS, AS200STSR Welded Channel Submittal