Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
AS 6024 Hex Head Cap Screw
AS 150S Channel with Long Slots
AS 601 Two Hole Splice Plate
AS 825 RH/LH Pipe Axle Support
286 Iron Cross Design - Discontinued
439 Structural "H" Slide Assembly
AS 449 Continuous Concrete Insert
AS 668 Six Hole Three Angle Connector
AS 619 Square Washer
AS 913 Ten Hole Two Angle Clevis Connector
AS200, AS200BTB, AS200BTS, AS200STS, AS200STSR Welded Channel Submittal