Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
Fig. 213 No-Hub Restraint
AS 646 Four Hole Splice Clevis
271 Pipe Roll Stand
164 3" Pipe Covering Protection Saddle
AS 3110 2-3/4" One Piece Cable and Conduit Clamp
AS 150S Channel with Long Slots
Loop Clutch
AS 3106 1-1/2" One Piece Cable and Conduit Clamp
AS 615 Four Hole Shelf Joint Angle Connector
AS LS Clamping Nut with Long Spring
AS520, AS520EH, AS520S, AS520H Channel Submittal