Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
FIG AS300 AS 300 Channel
AS 300, AS 300EH, AS 300KO, AS 300H, AS 300S Channel Submittal
274P Cast Iron Base Plate Only
AF773 Surge Restrainer
AS 678 Three Hole "U" Support
AS 400EH Channel with Elongated Holes
AS 200H Channel with Holes
Cable Toggle
AS 209 Flat Washer
AS 9404 Four Hole Hinge Connector
89 Retaining Clip
95 C-Clamp w/ Locknut