Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
FIG AS520BTB AS 520BTB Welded Channel
AS 2407 Wall Ladder Bracket
217 Adjustable Side Beam Clamp
47 Concrete Single Lug Plate
Stud End Clutch
165 4" Pipe Covering Protection Saddle
H-Pad Slip Sheet
AS 2128 RH & LH Six Hole Corner Connector
AS 927 Four Hole Corner Connector
167 Lok-Shield Insulation Protection Shield
271 Pipe Roll Stand