Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
FIG AS200BTB AS 200BTB Welded Channel
AS200, AS200BTB, AS200BTS, AS200STS, AS200STSR Welded Channel Submittal
AS 928 "Z" Support
AS 300EH Channel with Elongated Holes
AS 825 RH/LH Pipe Axle Support
206 Steel Side Beam Bracket
AS 3025FL Post Base
AS 901 Type "A" End Cap
AF310 Surge Restrainer
AS 3060 Offset Connector
Coupling End Clutch
AS 2521 Two Wheel Trolley