Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
FIG AS500S AS 500S Channel with Long Slots
AS 500, AS 500EH, AS 500S, AS 500H Channel Submittal
AS SS Clamping Nut with Short Spring
76CP Non-Conductive Roller
AS 520S Channel with Long Slots
AS 2580 Type "A" End Cap
AS 2560 1/2" Conduit Connector Fitting Assemb
AS 209 Flat Washer
137S Special U-Bolt
Ultimate-Span
Cable Coupling
AS 2504 Square Washer with Channel Guide