Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
FIG AS500EHBTB AS 500EHBTB Welded Channel Elongated Holes
AS 500BTB, AS 500 Welded Channel Submittal
148 Rod with Eye End
AS 907 "I" Beam Clamp
AS 927 Four Hole Corner Connector
AS 930 Type "A" End Cap
Fig. 213 No-Hub Restraint
157 Extension Piece
AS 604 Two Hole Corner Angle
50 Equal Leg Angle for Trapeze Assembly
278L Welded Eye Rod - LH
AS 711 "Z" Support