Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
FIG AS210S AS 210S Channel with Long Slots
AS 210, AS 210EH. AS 210KO, AS 210H. AS 210S Channel with Elongated Holes Submittal
AS 500S Channel with Long Slots
AS 400EH Channel with Elongated Holes
AS 2504 Square Washer with Channel Guide
439A Structural "H"
AS 708 Single Channel Bracket Support
AS 150 Channel
Cable Stud
274P Cast Iron Base Plate Only
Coupling End Clutch
AS 2580 Type "A" End Cap