Anvil-Strut channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus 0.015", on outside dimensions.
FIG AS520 AS 520 Channel
AS520, AS520EH, AS520S, AS520H Channel Submittal
AS 901 Type "A" End Cap
AS 3126 Hold Down Clamp
244 Pipe Strap - Round
AS 200EH Channel with Elongated Holes
AS 747 Symmetrical Four Hole Connector
256 Pipe Alignment Guide
AS 2580 Type "A" End Cap
AS 150BTB Welded Channel
202 Iron Side Beam Bracket
AS 2631 Swing Gate Fixture Hanger